|
ATV CLASSES $10 entry Fee per Class. 100% Pay Back.
- STOCK 335cc & UNDER 900 LBS 2X4
- STOCK 336cc to 425cc 1100 LBS 4X4
- STOCK 426cc to 601cc 1300 LBS 4X4
- STOCK 601cc and Up 1300 LBS 4X4
- UNLIMITED 460cc & Under 1250lbs
- UNLIMITED 461cc & Up 1500 LBS
A STOCK ATV is considered to have:
- Stock tire height and width.
- 1” variance on stock tire width
- No cut or shaped tires
- No wheel spacers
- No engine carburetor, exhaust ( etc) modifications
- Stock air box (replacement filter allowed)
- No weights within the interior of the four tires
- Maximum hitch height of 14”.
- ATV must have stock appearance
- Rear suspension travel not to be limited
An UNLIMITED ATV can have but is not limited to:
- Oversized/ undersized tires
- Engine Modifications
- Weight Boxes/Bars but not to exceed 24” from front of ATV tires
- Maximum total width of 60” and length of 70”
- Maximum hitch height of 14”.
- NO DEALERS OR DEALER OWNED MACHINES WILL BE ALLOWED IN THE STOCK CLASSES.
- PROOF OF OWNERSHIP MAY BE REQUIRED.
GENERAL RULES
- Driver must stay seated at all times
- Driver must wear helmet
- No sharing of weights with drivers in your class
- No more than 2 machines per driver per class
- No more than 1 run per machine per class
- Minimum of 6 machines to have a class
- No compressed gases
- No one under 18 will be allowed to operate in the unlimited class
- Official's discrimination will be used on stock classes
- No alcohol or drug consumption by drivers on pit crew before or during the events
- All machines must weigh out after their pull and weigh at or under their limit. NO VARIANCE
- All machines must have operating brakes
- If your machine breaks during your pull, you may fix it and move to the last position
- All machines will be inspected in line up
- Machines must have ATV chassis and engine
- Walking speed only. This is for everyone's safety.
- Anyone operating in the unlimited class must wear long pants.
- Hitches will be measured in a designated area with driver and weight on machine.
- BALL may not extend past rear tires or ahead of rear axle. Must have a 1-7/8” ball.
- NON-COMPLIANCE WITH ANY OF THESE RULES WILL RESULT IN DRIVER AND/OR MACHINE DISQUALIFICATION.
- ALL OFFICIAL'S RULINGS ARE FINAL. ANYONE CREATING PROBLEMS WILL BE DISQUALIFIED!!!
|
